Hey everyone,
I’ve been struggling with this issue for a while now and can’t find a fix. Hope someone here has experienced the same.
Setup:
• Quarq SRAM Force Powermeter (brand new)
• Wahoo Elemnt Bolt v2
Problem:
The powermeter is paired via ANT+ on the Bolt v2, shows full signal strength and status “Connected”. Cadence (RPM) is transmitted correctly. But power output is stuck at 0W the entire time, no matter how hard I pedal.
What I’ve already tried:
• Removed and re-paired the sensor on the Bolt v2
• Zero-Offset calibration directly on the Bolt v2 → works without issues
• Fully closed the SRAM AXS App to rule out a double connection via Bluetooth
• Restarted both the powermeter and the Bolt v2 multiple times
• Tested the powermeter with the SRAM AXS App → power values are displayed perfectly there
So the powermeter itself seems to be working fine. The issue is specifically with the Wahoo Bolt v2 not receiving/displaying the power data over ANT+, even though cadence comes through without problems.
Has anyone seen this before? Any ideas what could cause the torque signal to not come through over ANT+ while cadence does? Could it be a pairing profile issue?
Thanks in advance!