I'm trying to print a Hueforge and this is how the second layer is going down. the first layer looked perfect so I'm not sure why this is happening.
does anyone have any ideas why it is happening and any issues to try and fix it?
so i wanted to test out the Full Spectrum SnOrca fork and after painting a model how i wanted it to look i printed a couple of cubes and dialled in the filament blends a bit more.
The left wing is a bit too stripey and unfortunately i had a massive layer shift on the right wing but that didnt stop the print from completing thankfully.
i used Snapmaker Red, Yellow and White and Sunlu Blue to get 11 different shades. they are:
Skin
Left Foot
Right Foot
Tail Flame
Left Hand
Right Hand
Armour
Chest Piece
Left Wing
Right Wing
Eyes
the print took just over 25 hours and i think it came out rather well.
