u/South-Huge

hello,

I just install the M2 "fast" firmware from wanhao on my d12 230, because try to reach some better speed... they promis 400mm/s.

To be honnest I'm not really good to make good printing profils, and I would know how can I unleash the printing speed on cura, i would like at least to try 300/400mm/s but cura turn the case in yellow and i suppose they down the value to 150mm/s???

Does anyone know how to break this barrier or better, does anyone know how to really print at 400mm/s on a Wanhao d12 230???? Because wanhao service's seems to be dead...

thank you !!!