slope to surface sub assembly help
quick context: I have a wash using an assembly to show it being x' wide at bottom, having side slopes of 4:1 for x feet and then I want to have it slope from that point and connect to my residence FG at nearest point. in most cases on this design I can tell it to be like a 5% to my FG surface and it works fine, but there are a few spots where it does not.
Image shows the current assembly im using with the slope to surface and you can see it is going under the FG because thats where it has to in order to get to the surface. What subassembly should I use to have it just hit the closest point on the surface and the slope is whatever it is, so it shows more like the red line i drew in? Hope this makes sense. ignore any annotation as that was done for prelim design purposes
