u/Significant_Ad_8355

I just dusted off a cr-10 v3 that has been in storage for a while. I was able to power it up and preheat the end and bed. I was also able to run through the filament change and home with no issue so I know the heating elements and motors are all good. However, when I go to "print from tf" and select a file, it gets to "heating done" then just sits there and doesn't start printing.

I checked the card on my laptop and was able to read the files with no issue.

any ideas what might be wrong? I know that's probably not much to go on, so how do I troubleshoot this?

Thanks in advance!