Thanks for reading.
I've created a custom radio trim piece for my car in plasticity. I've been fighting it for 5 hours today. My elegoo CC prints all other stl junk from online just fine. But with my model it prints the purge line fine and then fails immediately. Under extrusion, blobs, no adhesion. I had a similar problem today printing a trash can, and I thought it was the new update to elegoo slicer so I downloaded orca and it fixed the issue....for the trash can.
I've tried countless bed leveling, different exporting file types, checking the hot end a million times, testing all other parts....and nothing. It fails immediately.
What I've learned so far....
Only my custom part fails. All other parts from online work great.
I have dragged the part into a sliced file with the same settings as a part that I know works fine, and it still fails immediately after the purge line
Purge line always comes out perfect no matter what
I've messed with the z offset and I can get it up in the air, or scrape the bed....no difference. Still blobbing up.
I've "fixed" the part in the slicer, changed bed types, temp settings, speed, nothing works.
Maybe the part is floating? Or the slicer isn't orienting the part correctly? Or maybe my model is broken and I need to start all over again....
Thanks for the help. I've given up at this point 🫠🫠🫠