Login

u/Piter061

▲ 31 r/AnycubicKobraS1+1 crossposts

Default settings for Anycubic kobra s1

besides:

print speed reduced from 300 to 200

infil gyroid

infil 15%

Edit: Fixed, runned once again bed and flow calibration

u/Piter061 — 13 days ago
▲ 1 r/AnycubicKobraS1

Hi! I have been using the filament backup option for quite some time which allows me to switch from a running out filament roll to a full one during a print so no filament goes to waste, however if i run out of filament(without the backup roll in another slot) the print is cancelled,

Is there an option to change it to pause the print instead? That would allow me to insert a new roll in to an empty slot and resume printing instead of throwing away half finished print.

Thanks!

reddit.com
u/Piter061 — 17 days ago