u/No_Performance565

Hi all,
Was just tidying up my installation after testing with everything apart. I didn’t realise one of my mounting screws in my 3D printed case was sitting a bit proud and may have been touching a component on the PCB.
After a little flash I pulled apart the machine to find the PCB looking like this :(

Any chance it’ll still work or should I look at replacing the component?

Follow up question what would be the best way to insulate the damaged part from the screw if it still work?
Thanks!

Hi I used a vacuum seal lid with a fermentation weight pushing the peppers and garlic and tomato’s down.
I used a 2% salt ratio and it’s been about a week and a half since i put them away in a cupboard.
Any help appreciated!