I was thinking of buying the filament maker from Creality, but was hesitant about buying the shredder as it might be too much. is there a better alternative to the filament shredder that works for most filaments? (preferably PLA and PETG)
Ever since I've gotten my 0.4mm HF nozzle for P2S, I've been unsatisfied with how little it does. I've spent probably a week or two trying to test and research how to make the high flow nozzle more effective. When I first got it, the print time actually was around 10 minutes higher than standard flow every print. after some setting changes, i would get times either 2 minutes below or equal to standard flow times, and with terrible print quality. then i finally fully calibrated a filament, temperature, volumetric flow, flow rate, pressure advance, and i only really achieved around 15 minutes less than standard flow for a 2 hour PETG print, providing a 12 percent improvement. So far, high flow hasn't been worth it for me, and i really want to know whats going on, if there really is something that can be done about it.