So, Friday I had started a long print and left home. When I came back, I had the angry spaghetti; the front fan was on the bed, and I had no idea how that could have even happened. Ever since then, I’ve noticed when I home all axis, it lands in the front half of the bed and a little to the left. I noticed it still knew where the poop shoot was and the ends of the bed, but I had no adhesion with anything.
I thought I might have that bed warp issue, so I flashed Rinkhals and did a meshmap, and the back right corner was way down (Max .206, Min -.726, Range .931). I even tried to move the bed screws in and out a bit to see if, maybe, I can get a more even bed. No matter how hard I try, I can't get it to print.
Looking at the bed, I didn't have a headcrash. I’ve washed the PEI sheet with warm soapy water. Filament does come out, I can get it to move to where it's supposed to go, but it's almost like I don't get that squish for PLA; and PETG, I haven't been able to get working either. After trying literally everything, I decided to do a full factory reset, removing Rinkhals, and still won't home in the center of the bed or anything.
Before I try belt skipping or trying to explain why my ~80 hours print time needs a $200 dollar bed, is there anything I can do? I am starting to run out of ideas. I did a ticket with support, but this was bought second hand, so I don't have warranty. I just want to print again, as I am mid-project and I want to finish, lol.