So... I bought funssor 5mm and 8mm bed/carriage combo.
And even after many tried my bed is not flat. It's warped, any ideas as to why? I mean is not horrible, but my vyper normal printer is flatter than this, I feel a bit disappointed.
So, today I had two weird issues.
I've sent to print some 3.5hs print, the first time at around 1.5hs the printer said the print was complete and successful however it only printed 40%.
So I re-sliced the object and sent it to print again. Now it went for 2.5 hs before doing the same.
Basically at random point during the print it just assumes it's finished and homes back the nozzle and that's it.
It's not air printing, the print literally says it finished earlier than what it should so for some reason I can't understand it believes it's done earlier.
Any suggestions?