I had a 9 panel non-dot lab test. I stopped smoking for 32 days but was still testing positive so didnt really have a choice. I did a lot of research before using it. Here’s what I learned.
They only flag it to look at it closer and test for biocides or preservatives (which will confirm it’s synthetic) if it has nitrates or if the chemical composition is different from human urine. Which makes sense, why would they do more work to prove it’s fake if it seems like a valid human sample. From what I learned, it should only get nitrates if you over heat it, and the chemical composition like ph would only be off if it’s expired or fake, so make sure you verify the batch number. Here are the steps I took.
Got 6.4 plus from local smoke shop and verified the batch number. Since I was worried about overheating it and causing nitrates, I activated the heat pack that came with it and rubber banded it around the back of the bottle (not the side with the temp strip). Remember to take the seal under the lid off. After about two hours it was at 92. Then I used a head band around my thigh right by my junk to conceal it, along with compression boxers and jeans. I drove about 20 mins with seat warmers on and then waited about 20 mins to take the test. When I took it out it said it was at 100, and when I put it in the cup it said 96. They said I needed 60 ml in the cup so I put in between 70-75ml to make it seem more real, not to an exact line. Then I actually peed a little in the toilet. Put it back in my spot and opened the door, handed to collector who just checked temp and sealed it and I signed off. I’d recommend practicing opening the lid quietly. If you put pressure at the top and open it real slow with your thumb it’s practically silent, the collector does stand right outside the door. They said they’ll send it to the lab and it’ll take two business days for the results. After about 3 business days I received the last onboarding instructions which means I passed.
I was very nervous but it does really work. Just act normal. The most nerve racking part is waiting for the results. Basically, as long as you verify the batch #, don’t overheat, and get the temp right, you are good. It will work. It is literally made to mimic the chemistry of human urine. Hope this relieves some stress for somebody cuz I know I was stressin out and reading through every post on here. You got it.