Because I PULL. I pull the wheel towards me because i'm focused I guess. No I can't change the pulling, and yes I'm on a chair.
CSL DD 8 nm qr2, I am currently on metal whel side qr2 and plastic base side qr2, I ordered a metal base side qr2 and I hope I will solve the problem.
It was not the firmware ( I did hope it was ), after hours of desperation and testing I came to the conclusion that it's just the pins loosing contact with base. When I pull "hard", it disconnect, simple.
But is the qr2 base the culprit ? Wheel side ? I tried to bend the pins to the outside, then in, no improvements.
I plan to continue bending the pins, I'll post the "results" here.
I ordered formula v3 and cs dd+ I am very sure I will pull the v3 even more... If only I could go usb easily and kep telemetry.