I’ve owned a mckillans foam canon for a bit but after changing orifice size from 1.1 to 1.25mm due to my active 2.0 I’ve only had runny foam. I’ve tried all sorts of fixes but compared to my recently bought quivr foam canons the foam quality is nowhere near the same. I’ve interchanged some of the parts of the quivr canon and used pin guages to measure orifice size as well as replace the mesh filter. As far as I can tell foam canons shouldn’t have that much of a build difference so I’m lost on what the issue is. I’ve also tried tightening down the knob on top which controls foam amount.
Setup details:
Active 2.0 (recommended with 1.25mm orifice for power draw and 2gpm flow.)
Uber flex hose
Normal hose water (hard water)
Mckillans equipment
Quivr foam canon