u/JammyM1812

Hi folks,

I've had my K24 for nearly 8 years, and I've just started to notice that the lid doesn't have a snug seal anymore. When I close the lid it moves up about 2mm at the front, so I'm losing a bit of heat when I want to do low and slow.

I think it might be the hinge at the back as a few of the screws look to be out of place.

I'll be replacing the gasket and vent at the top this year as they're pretty worn.

Wondered if anyone has come across this issue and if you could recommend a fix? Is it a case of replacing the screws/washers? If so, any recommendations?

Thanks in advance!