u/ItzFrosty45

Hello friends, yesterday I posted about a strange print failure. I am back with an update. I ran another print and goodness gracious did it get weirder. I have no idea what on God’s green earth happened this time. I posted the photo and am at a complete loss for words. It seems as though it failed to print several dozen layers of the models, but then it did? I’m so lost as to what happened. one model seemed to print, and technically parts of the models printed. This is so strange though. if anyone has any advice I am all ears

I ran a print with 4 models on it today. Only 1 ended up printing, the other failed after the rafts and a couple supports. The other one printed all the way, but with a few strange failures on its arms and stomach. No idea what could cause this, so I figured I’d post it here. Weird gap in his right arm, and parts of his left arm are super flat?
I have an Anycubic Photon Mono 2, and I replaced the FEP screen within the last two weeks. Brand new resin, the owlbear model is from Loot studios, the other models were from Cults 3D