u/Intrepid_Stop9274

I am working on the Joshua bardwell sub250g FPV drone analog build. I have the flight controller in with all 4 motors soldered on and on the frame. Battery lead and capacitor are both soldered to FC. I have the VTX and camera soldered on. Camera is mounted. Will wait to mount VTX until I get my goggles to make sure it works. I also need to get a receiver, probably radiomaster RP1 and solder. Also I need antennas for both video and transmitter but I have not done that yet. I’m probably at least a good $150+ out from being in the air. All I need is a receiver and goggles and hopefully get cheap ones. Just have to save up!

I would recommend this one from beginners on a budget and the digital system from people with more money.

Just finished printing the Cozy RC mini mono. I have to change the current ESC because it is not powerful enough for the motor. Also the receiver needs to change. Meanwhile I need to assemble the hull and waterproof. I think I will epoxy the outside. Also should I put epoxy on before or after glue.