What gives with this start stop? HELP PLEASE
So I scrolled a few messages down... And didn't see my particular issue. Man do people have issues... I never dreamed of so many problems people are having. (Speaking of ill contribute what little knowledge I have, unless people feel I should hold off until I've proven myself as a competent maker.)
But anywho. Back to my story/journey/issue... I stumbled up hill upon unboxing chasing symptoms I had no Idea what they meant... So I asked AI... What a rabbit hole that led me down... Long story short. Don't rely on AI for advice on print quality from pictures. They lead you astray, or at least it did for me...
So my base line cc1 has some cheap Amazon hardened extruder gears which for some reason makes my extrusion rates way off. I've ran the 120mm filament length check to see about the esteps and the remainder was 20mm after the 100mm pull. I reset tension mechanism for x y belts in rear... (Stupid mechanism). I retrammed and levelled bed at 35c using gcode I had written and dial indicator.
So my issue is the starts/stops or so I'm guessing... You can clearly see a perfect ledge right in the diagonal and on a non rotated cube instead of ghosting you can see the layer of filament below the top layer. Like little hole from no filament there and filament somewhere else... Also my purge line shows a very tiny, tiny break between the final stop start with a bit of a blob at the beginning of the last feed...