u/Hector_van_der_Aa — reddlx

Hello there,

I have been using my JLink V9 clone all day to flash firmware onto an Arduino Giga (STM32H747XI)
After unplugging and replugging it I all of a sudden started getting a whole load of error message, boiling down to Error: Failed to initialize DAP.

I strongly believe that something is bricked in the probe as I have tried it with another known working Arduino Giga, different cable and it gives the same error.

Multiple times when running JLinkExe I got an error message saying my probe was in bootloader mode and that I had to update the firmware.

Does anyone have any experience with these Clones and reviving them or should I just accept defeat and buy the real things?

I am happy to test things out so long as they don't pose a risk to my (rather expensive) Arduino's

Any help is appreciated as this has just become a huge roadblock in my project.

Best Regards,

Hector

Ever since I left Omarchy(only lasted 2 weeks on it before I gave up) to move onto a custom Arch install, I have been chasing the perfection of gruvboxing it to the max.

I'm also a big fan of all of the lazy apps, a few that I use are:

Lazyvim
Lazyssh
Lazygit

The rest of my setup is roughly as follows:

Browser - Zen
Terminal - Kitty
File Browser - Nautilus
Emails - aerc
And about 50 thousand other things I can't remember

I'm also big into audio, I have a pretty complex audio routing setup powered by pipewire and thanks to qpwgraph for easy gui routing and carla to run all of my processing plugins

If you have any questions please feel free to ask, I will do my best to get back to you when I can!