The Debbler am final hav nuf of Nolar Gray Man. Aftr Nolar Gray Man Am giv the Debbler spaec scruvy, The Debbler am loss al bot 1 toof.
The Debbler no Nolar Gray Man am not tak acountbilly. The Debbler am tak in ohn ✋️
Am highr lady vers Dolan 2 am kil Nolar Gray Man.
Lady vers Dolan am do wel.
Rip in piec Nolar Gray Man. Am no god gy
The sub can finally go back to nutriding a probable rapist who got karmic justice in the form of a helicopter crash
Here am Mank Gray Man, Slotterng Threggy Merkty kids.
Am try gaslit by tel "hey u am do dis" but we no ture Mank Gray Man.
Ture Mank Gray Man go rond, brek toylets, mamke atom eev fatgurl. No am god guy. We am wotch him kil Angertom LeviJeans 2.
Threggy Merkty am rite no lik Nolar Gray Man an Mank Gray Man
Mank grayman am no reel plant butser. If nolar grayman do boom boom on pooping tubie he mak whole in da erth.
Mank grayman? Mur liek Mank WEEKman
U ken wat I sed?
​
Ive tried a few of the modern day fightpad controllers, and I have to say ive been extremely disappointed to find they ALL suffer from the same or similar issues.
Those being the dpads. The awful dpads. It didnt matter what controller I got.
The razer raiain? Physically impossible to do 360 motion inputs on it. Even half circle motions were pretty touchy, and required you to deliberately slow the input downs. This controller cost me 90 dollars and essentially was a very light paperweight.
The hori octa pro? Same deal, 70 dollars gone. At least it has no issue with half circles. Outside of 360 inputs a fantastic controller
The 8bitdo m30 is probably my favorite one of the bunch due to nostalgia reasons alone. The dpad feels fantastic.... except for one problem. There nothing to prevent the center of the dpad from being pushed down, which causes similar issues with 360 inputs. It wasnt registering cardinal directions, only diagonals
However I found a super easy mod you can do to the controller. It took a while for me to find it so I figured id share it here.
All you have to do is remove the 5 screws in the back, and use a pry tool(the best spots to start are the bumpers as you can pop it open from both sides and follow down)
Once you get it open, just lift the board out, the screws holding the case also secure the board. Flip it over, and put 3-4 pieces of electrical tape right in the center of the dpad location. This raises the dpad just enough, that you cant push it down and register inputs from the center. Completely removes the issue I discussed about it.
Happy gaming with your top tier 25 dollar controller