When i was adjusting my 20 yard pin and tightened it fully (at least what i thought was fully) i noticed the pin was to the right of the others. Im not really sure what causes it, but when i loosened the pin and tightened it just enough for it to not move it looked like it sat flush again. Was this caused by tightening the pin too much? (When I did this yesterday the pin was even further right than shown in the picture)
I'm still kinda new to this but I recently adjusted my bow from 45lb draw to 60lb and was trying to adjust the 20 yard pin. I tightened the pin until it was snug (or in my opinion snug), but when I did this I noticed the 20 yard pin was to the right of the other pins. What could cause this? can you over tighten the pins to the point where they're no longer in line with the others? I'm not really sure what im doing wrong in adjusting it. Once i loosened it slightly I noticed the pin kinda fell back in line and wasnt able to move freely (as far as i could tell). Thank you for any advice!
