u/Fragrant-Resident-99

I just got the U1, and I have ran into the toolhead swapping anomaly error on every print so far. Each time I go and look at it, see no visible problem, press continue, and it just goes on like nothing was ever wrong. At first it seemed random, but today, I did a print with just one color. I went with no error until the very end, once the entire print was done, I got the error again.

After investigating, It seems like the error pops up on the first toolhead swap of each print. It seems to also be on every toolhead, as this error has happned on toolead 1,2, and 4 so far.

I am on the latest firmware, and I've attempted to recalibrate.

I've contacted support, but Im just wondering if anyone has any ideas or experieocned the same thing.