u/Forsaken_Can_1785

Newbie here. Been using the heck out of my vanish 340. I have pulled up so many pull tabs and cans I’m getting to the point I wish I had more settings to eliminate but everything I read says “dig everything”

I was pulling cans /tabs up around the 16-19 range almost every time. I pulled one nickel up at 13.

I’m using the jewelry mode with two notches up on sensitivity.

Is it safe to say I can ignore a lot of the tones that are in the 16-19 range?

Can I utilize the sensitivity at its lowest to sweep then pinpoint with sensitivity higher?

Any suggestions I would really appreciate thank you!