From being a Harley owner and finding it t easy to adjust the clutch friction point, Im finding it difficult to change gear when the friction point is at the very beginning of engaging the clutch and at the very end of realease. I’ve gone through all numbers on the dial. Im on 1. Im next going to replace the clutch fluid and see if that helps. Any advice is appreciated
If you remove the and on a r1200cl do you have to replace the brake lines? If yes, why? My abs is working fine. Jive gone through all the trouble shooting of the blinking alternating lights. I’ve done everything but put black tape over lights.
I bought a 2004 r1200cl. Everything works. Abs is functioning but with alternating flashing lights. I plan on converting the abs to non abs. But while it’s working I’d like to figure it out. The bike side stand was bent to where the bike leaned too far over. I had to cut and weld the bracket to keep it somewhat upright. I realize the previous owner remove the side stand sensor. I’m trying to find where it’s supposed to connect to so I can see if I can run a jumper to see if the flashing will be fixed. Where is the connector for the side stand sensor. Want to check before I change over to non abs