No AMS: how to prevent this
Printing with Pla+ and 0.1mm layer. I planned a pause and changed filament manually.
Important to report that the printer usually freezes on the filament change screen. Thus i had to shut it down and wait for the previous print to load back.
I have to load as well manually the new filament (modifying hotend temp manually and processing manually the filament through control) to avoid using the filament load which also freezes on first step....
While going back on process, the printer would stop printing at each layer, going to the poop tray, on the course back, a few mm of filament will go out resulting in an extra material on the first application.
Eventually at the end, it looks quite terrible.
I'd like to say too that it's a 3h30 printing and pause at 1h40.
I had absolutelu no issue (no freezes or else) on lighter prints.
If somebody has any clue about this... I've more to print liké this
Thanks in advance