So I recently switched to debian 13 and wanted to use my R3, but using boxflat I quickly found out my inputs are laggy and ffb cuts out especially when having 2 pedal inputs active. I have tried disabling steam input and install the universal-pidff driver, but to no avail. In windows it works fine. Thanks for any help
So I am experimenting with FreeCAD and am hitting a wall, I would like to use cambered NACA airfoils and create wingtips for them by lofting the upper and lower surfaces through an intermediate, perpendicular curve.
Now, with the surfaces workbench I can create the surfaces, and then convert & merge them back to the main wing with the parts workbench, however I cannot figure out how to control the start and end tangency, which leads to the surfaces not flowing nicely from one to the other.
I have attached the pictures of what I have been trying to do, and comparing with the one in onshape, where tangency control is included in the loft tool.
Please help me figure this one out, as I could not find any tutorial that adress the fact that my lofts have singularities and shared edges without adding a lot of additional guide curves; Thanks!
