Hi, is there a way to query and manage Aquaris from command line?
It disconnects very often and it would be easier to write a script to automatically queries state and reconnect if needed.
It's very annoying to click "connect" every few seconds, and since Tuxedo Control Center is a JavaScipt app sometimes Aquaris page doesn't refresh, so I have to click through multiple pages before I can see "Connect" again, very annoying.
Hi, I've got Stellaris 16 Gen5, and I have strange "power mode" behavior.
Very often (basically always) when system starts cpu frequency goes to some minimal values (average around 800Mhz).
I have custom tcc profiles, it's copy of "default" with minimal cpu frequency set to 1.8 Ghz.
So when system starts this setting is generally ignored, and manual switching profiles also doesn't work, it does not switch to minimal 1.8 Ghz
but if one profile is set to "battery" mode and my is set to "Mains", then unplug, and plug again fixes the issue, CPU switches to 1.8Ghz.
And now I have a similar problem with GPU, but I have no solution.
I use only nvidia GPU intel is disabled.
sometimes (on windows and linux) GPU start working correctly (core clocks are ~3GHz and memory ~9Ghz), but after few seconds it switches to some low performance mode (pstate=8) and doesn't allow to pull more then 20W of power.
nvidia-smi -q -d POWER
==============NVSMI LOG==============
Timestamp : Sun Apr 26 17:05:01 2026
Driver Version : 580.126.09
CUDA Version : 13.0
Attached GPUs : 1
GPU 00000000:01:00.0
GPU Power Readings
Average Power Draw : 8.12 W
Instantaneous Power Draw : 7.76 W
Current Power Limit : 20.00 W
Requested Power Limit : 20.00 W
Default Power Limit : 150.00 W
Min Power Limit : 5.00 W
Max Power Limit : 175.00 W
Power Samples
Duration : Not Found
Number of Samples : Not Found
Max : Not Found
Min : Not Found
Avg : Not Found
GPU Memory Power Readings
Average Power Draw : N/A
Instantaneous Power Draw : N/A
Module Power Readings
Average Power Draw : N/A
Instantaneous Power Draw : N/A
Current Power Limit : N/A
Requested Power Limit : N/A
Default Power Limit : N/A
Min Power Limit : N/A
Max Power Limit : N/A
and there's now way to switch it to normal power mode.
nothing works:nvida-smi -pl 175
cat /etc/modprobe.d/nvidia.conf options nvidia NVreg_RegistryDwords="RMforcePstate=0"
I've noticed that updating drivers in windows also changes power settings, but this works until next reboot.
maybe there's some magic command set/reset GPU in normal power (mains?) mode?
sometimes GPU starts normally then switches to low power mode:
