Hey there -
My studio recently got a Wasp Delta 2040 and I'm trying to get it up and running for them. The initial extrusion test goes about halfway down the tube and then stops. I saw one other post in this sub from 3 years ago but I'm going to make a new post and see if anyone else has experienced this and what I can do. It's been pretty dang frustration, because I do feel like I have the clay they sent to the exact same consistency as they have in their demo video. I have tried to make it wetter, and significantly wetter, too, and I cannot get it to work.
My air compressor is set to around 8 bar/about 116 psi, and on the printer it is at 5.5-6. I've tried turning it up a bit to see if it helps but nothing has worked so far.
Thanks in advance for any insight