u/Dwiea

I have been working on a project for a while and it has gradually become more and more complicated (maxed out pins on a ESP32-S3 except the strapping pins) to the point where it is like spaghetti and getting the final traces from the mc to the connectors on the side of the board is going to take a lot of shifting up and down vias.

My sphaghetti area

Does anyone have tips or process for making sure tracks dont block each other (I know it isn't always possible but I would like to reduce it if possible.

I was thinking of trying to make a block diagram and just physically draw lines then change the pins in the schematic around so the traces will at least come out ont he correct side of the mc?