u/Delrithion

Hey folks! I'm, just getting into trying to print some minis and have had some mixed results. Some have turned out pretty good, but I'm usually taking a couple of attempts to something working that doesnt fail in the first hour or so.

Setup:

• P2S
• 0.2mm nozzle
• Bambu PLA Basic
• Fat Dragon settings ( was recommended by a friend and internet seemed to agree - i have seen some other names floating around as well but havent tried any other profiles )

My most recent print took 3 tries and I looked into resin2fdm to get it finally printed, but the sword is super wonky.

• I slowed down my print speed on this to print no faster than 30mm/s across the entire print which i believe led the to increased quality overall?

What can i / should i be looking into for a better success rate / better quality prints when i have smaller areas like a sword?

Does it come to just bulking up those sections / adding more supports?

Any suggestions are appreciated! Thanks!

A couple pics of my latest print mentioned + some more successful ones I've had : https://imgur.com/a/zg4ZIKm