u/DazzlingAppearance63

Hi all,

I’ve had a few issues with getting the routing of my 2 AMSs and my HT correct. The filament sounds terrible going through the PTFE tubing now and I’ve had two failed prints for what looks to be under extrusion. Attached is my current set up. Looking for any advice on how I should position/route them. TIA!

I’ve been waiting on this for a while. There is a noticeable tick when closer to the ear, but a marked improvement over some of my other Timex movements. The band is pretty bad, and I’ll get that changed quickly. Overall I think it’s a nice little watch, and definitely overpriced a bit. I love the sizing; I’ve been on a vintage sizing kick for a now.