u/DJ_chromeosome

Just got a new rear tire put on and went to reinstall the wheel and noticed that the right bearing pertrudes out slightly. Not sure if this should be sitting flush or if its fine the way it is.

It is tight against the wheel and won't seat in any further. Did not tighten the rear axel nut yet so I dont know if that would push it in any further or not.

u/DJ_chromeosome — 11 days ago

▲ 1 r/Ninja400

Im putting a new front sprocket on my 2020 Ninja 400 (ABS) and wanted to know what's recommended to put on the threads. The manual says about putting on an oil/moly blend but I have seen posts about people using either thread locker, anti-seize, or both.

I also see that the manual calls for 94 ft-lb. Not sure if that's calculated dry or with lubricant.

Any guidance would be appreciated.

reddit.com

u/DJ_chromeosome — 14 days ago