u/CreditManiac21

Hi all,

I have an A329S and I’m just curious what the parameters are for it to say “impact detected during parking recording”?

For instance when I initially park, and it goes into parking recording, and I slam my door to leave, I hear it save the clip (with the screenshot sound), however, upon re-entering the car and starting it, it doesn’t say impact detected during parking recording.

However, if I slam my car door 5 minutes into parking mode, it will announce “impact detected during parking recording” upon starting my car.

Therefore, there must be a buffer of some sort before it announces an impact detected? Maybe 1 minute or 90 seconds? I do not have the 90 second parking mode delay on.

Thanks in advance

Hi all,

I have an A329s and I typically use hybrid parking mode on low bitrate -> low power impact detection. Earlier today I had it in parking mode while I was at class and it only recorded about 3.5 hrs after I parked.

The last clip before it shut off was around 35 seconds and my typical loop recording is at 5 mins.

I’m curious if maybe this was a one time fluke? It’s worked fine until I saw this for the first time today. I was parked in the sun, the micro sd card is full but it should loop record and delete the oldest, and in the last recording my battery was reading 12.47V and I have the cutoff at 12V. If any of that matters. But it fully turned off and didn’t go into low power impact detection.

Do you think this is a one-off or a possible problem?

Thanks in advance