Airfoil Scan Issue in Zeiss Calypso "Error with References
Calling all Calypso 3D scan measurement experts - please help!
I'm currently tasked with a rather large project rescanning and measuring airfoils. Each airfoil has a measurement regime across three airfoil sections and all of the measurements are working except for one. I did not do the initial programming in Calypso and although I am my companies SME for scanning we don't normally use this software at all so I'm struggling to find where the issue is.
I have performed these measurements on two different airfoils to ensure that it wasn't a scan/STL issue and it happens on both. I have also checked the program vs the two other section programs and other then nominal values variation everything seems to have the same basic setup so I'm unsure where to go from here.
What I've Checked:
- Alignment
- Clearance Planes
- Characteristics Nominal Values and Tolerances
- Features - Feel like my issue is here but don't know where to start but only 4 out of 13 features programmed are green boxed on left
Any suggestions at all for anything else to check would be appreciated.