u/ChuDachan

Hello everyone! I've been diy-ing this acrylic container for my Giant Shield. I wanted to make sure there's enough cross ventilation before glueing the plastic mesh to the sides so i don't risk burning it while trying to melt more holes with a soldering iron. This is how it's looking so far, would you suggest I'd make more symmetrical holes on the bottom where the red circle is? Of course I'd then make them parallel to the other side as well. The lid will be entirely made of mesh! Also if you have extra tips I'll gladly take them as I'm fully new to this. Appreciate all the help, have a picture of Flat looking especially flat as a thank you!