u/CMMGUYHERE

I have a slot with a straight side and a round side. The print calls out the width across the 'D' and sets it as a datum with a max material modifier. How would you do that? I used auto line to pick up the straight side and auto circle to pick up the round side.

What I've tried so far: 1st, I tried to construct a width between the line and the circle. Couldn't get it to work. I'm guessing because it's a line and a circle.

2nd I tried constructing a pierce point on the extreme edge of the circle and the center of the line, tried constructing a width between the points, didn't work.

3rd, tried constructing a line parallel to the straight side at that extreme point. That worked. Tried to construct a width between that constructed line, and the straight side, didn't work.