u/Blisspoint2

I posted this in r/pools but figured it might be a good idea to put it here as well.

I am replacing the motor assembly on a Pentair Superflo VST variable speed pump. The old assembly had a connector to the control box that came out with three wires from the assembly as yellow, red, blue then went into a plug to connect to the controller as yellow, blue, red. The plug is also shaped special (circle with one square edge, then two circles) so that it can only plug into the controller in one orientation. The new assembly has wires coming out that are brown, blue, white and goes into the plug as blue, brown, white. The plug is also shaped as three squares.

What do I need to do to get it to install correctly? Has anyone else run into this problem?

I am replacing the motor assembly on a Pentair Superflow variable speed pump. The old assembly had a connector to the control box that came out with three wires from the assembly as yellow, red, blue then went into a plug to connect to the controller as yellow, blue, red. The plug is also shaped special (circle with one square edge, then two circles) so that it can only plug into the controller in one orientation. The new assembly has wires coming out that are brown, blue, white and goes into the plug as blue, brown, white. The plug is also shaped as three squares.

What do I need to do to get it to install correctly? Has anyone else run into this problem?