My friend gifted me a 3d printer that’s been collecting dust, I’ve wanted to get a printer for a while but just never did the time to research one and pull the trigger.
Fast forward to my friend giving me this adventure 5m. He bought it for his nephew which ended up getting a better one for Christmas, so it’s got 0 prints on it. I looked at confirmed hours on the display and it’s legit never extruded a bit of filament.
However it’s sat for sometime and he set it up but never tested it.
So my advice I seek, what can I do to make sure it’s fully setup correctly? I watched some YouTube videos but those are like first time setups which is fine, my concern is that it sat for sometime and collected some dust and potentially could have missed something.
Also any upgrades to purchase now/ for the start?