I know they’re different filament which could be an issue with calibrations, but I just didnt have the red benchy that was printed similarly to the right. The left benchy is the one pre programmed on the ad5m pro and the right is one off of the usb stick. I’m using default settings on orcaslicer for the .4 nozzle with calibrated filament. I am trying to figure out what could cause the issue on the front on the right benchy. I got the printer for Christmas this past year and have printed a decent amount done all the maintenance on the machine as well. My prints were decent in the beginning but always have slight imperfections here and there. Am I just being a perfectionist or are there settings to correct these type of things. I have some other posts on here regarding different issues I have found in prints and just can’t figure out what settings to adjust to make them perfect. Is this a normal thing while 3d printing?