u/AlexMurdoch99

Hi team! I am still struggling with my Core One and this horrible noise it makes when printing Gyroid Infill. I have been scouring the forums for solutions - and have tried:

- loosening and tightening all accessible screws

- precise belt tuning to spec

- loosening and tightening the screws holding the LM10LUU linear bearings on both sides

- removing and re-attching all panels

I'm stuck!! I have just opened a support ticket - but would be pumped if any of you guys had any input. I'm keen to keep troubleshooting.

See the video for an example of this noise.

I am on the latest PrusaSlicer, firmware, and am printing with Prusament PETG on the default settings.