3D Printed Tachyon Spacers
Made and measured them myself so here are the three configurations!
Original Spacer: ~1.18 Grams
Full Length + Two extra screws (stabilisation): ~1.25g
Top half + Two extra screws: ~0.98g
Bottom half no extra screws: ~0.48g
Due to most of the handle bias coming from the thick handle slabs, the spacers dont do too much to change the balance, HOWEVER, here are some of my thought of each spacer
Full length: More handle bias and hefty, not enjoyable unless you have tanto blade(?)
Top half: It's suprisingly good, feels slightly less h.b if you only screw in one screw on each side, on the top and the bottom, this reduces weight but keeps it stable
Bottom half: Unstable and tends to shift when flipping, this is caused from lack of spacer alignment as we only use one screw to lock it in place
Overall: Fun to make, I shall open source the stl files and i hope you enjoy them!