Please Help Me I’m Going Insane
This is my 2009 FZ6R. It was running perfect until i decided to add turn signals. I added the rears and everything worked fine. But moving to the front turn signals I had to tap in to the turn signal wires coming directly from the turn signal switch on the left side. I grounded the front turn signal wires to the 10 pin connector ground wire via splicing. I checked the turn signals to make sure they worked and realized i had blown the ignition fuse by accident. I replaced the ignition fuse and everything looked fine. At this point i hadn’t put the tank and air filter back on. But fast forward to the next day I went outside and put the air filter/tank on and tried to start the bike. Immediately i noticed that the fuel pump wasn’t priming. I checked all fuses and the fuel pump relay makes a click as if it’s working correctly. I tested multiple wires for voltage and have found that the fuel pump connector is not receiving voltage and the blue/black safety wire from the ignition is not receiving voltage as well. other than that everything is receiving voltage and everything else on the bike works. Currently I have all wiring back to how it was with both front and back turn signals disconnected. All of the ground wires are grounding correctly is my ecu fried? Thank you in advance!