I have an SKR mini e3 v3 and just installed a TFT35 v3.0.1
My bed leveling was working perfectly fine before the screen switch, not it’s not working. Is this something on the firmware side?
Hello, I was wondering if it’s possible to run two cables to have independent Z stepper motors,
For situations like running G34, however I’ve heard that this isn’t really possible since the board have only 4 drivers? However I see in my board there’s a ZAM and a ZBM… does this mean anything?
I’m running marlin, with a TFT35, I’d real like to be able to align my Z steppers cause there’s always some tilt I adjust for…
Is there any add on boards I could put if the Skr doesn’t end up supporting this?
Hello I just got a CR touch after my BL touch kicked the bucket, I’ve read online that the wiring was backwards between the two, and that the CR can directly be plugged into an SKR MINI e3 v3 board,
I haven’t gotten around to playing with firmware but I just wanted to ask you guys before I go too deep and waste my time trouble shooting incorrectly connected my