During the print startup sequence, my P1S emits a loud and startling screech sound. I'm not sure how long it has been going on since it is located in a different room when I start a print job. Other than the initial noise the printer seems to function normally. Ideas 💡?
Finally pulled the trigger to print the first piece of a drone project I'm working on. The print looked good but, bonded too well to the Smooth PEI Plate when using Bambu Lab liquid glue. I applied the glue per the Bambu Lab video. It worked on smaller pieces. So, now what? Clean the glue from plate and try again or wipe it down with alcohol then try again? Try something else? I used Bambu Lab ASA-Aero. Hot plate set to 100°C. Head temp 255°C. Ideas?