Hello all!
So, we've been to Kauai several times, love to hang out in Koloa/Poipu area. But I'v been wondering what the trees are that you see off to the left as you are heading south on Maluhia road a few miles after the tree tunnel. They are quite tall and fan out quickly at the top, with quite flat tops... Remind me of the trees you see on the African Savannah!
Anyone?
Hello fellow Orca Slicers!
So- I ran across this this afternoon and it's left me in a quandary...
I modeled this up in F360- a very simple little tool. A .1" flat base with 9 little tubes sticking up about 1.5"
I sliced it in Orca Slicer and it gave me 2 hour, 42 minute print time. I remembered that the first layer was exceptionally slow, so I re-sliced it, bumped up the speed considerably, and it gave me a 3 hour, one minute print time?? See attached screenshots...
I did nothing but change the speeds. I even re-sliced it a few times to see if anything changed... nope. Faster speeds equal slower print time.
I don't get it...
Any of you OrcaPros out there have an explanation?
